FrameBoss XPM - ITW Proline

Trends

The Ramset™ FrameBoss™ XPM

The Ramset™ FrameBoss™ XPM is a fully automatic powder actuated tool, capable of fixing 10 pins without the need to reload or cycle the tool. The magazine can be adjusted to lock into several positions, allowing the tool to be used in confined spaces. With a huge 400 joules of impact energy coupled with power adjustment, the tool can be used in a wide variety of applications including Timber framing, formwork and the fixing of steel track.

FrameBoss™ XPM is designed to get the job done quickly and save you money.

The Ramset™ FrameBoss™ XP

The FrameBoss™ XP comes equipped with a single shot fastener guide to allow the tool to be used with longer fasteners and assemblies such as brackets and clips. The slim and ergonomic design makes the FrameBoss™ XP ideal for use in confined spaces. With a huge 400 joules of impact energy coupled with power adjustment, this tool can be used in a wide variety of applications e.g. Timber framing, formwork and the fixing of steel track.

The Ramset™ FrameBoss™ XP

The FrameBoss™ XP comes equipped with a single shot fastener guide to allow the tool to be used with longer fasteners and assemblies such as brackets and clips. The slim and ergonomic design makes the FrameBoss™ XP ideal for use in confined spaces. With a huge 400 joules of impact energy coupled with power adjustment, this tool can be used in a wide variety of applications e.g. Timber framing, formwork and the fixing of steel track.

Standard Operating Procedure

Always read and understand the instruction manual before attempting to operate a Ramset™ powder actuated tool. Ramset™ also recommends users obtain personal instruction and training from a Ramset™ representative. 

  1. First cycle the tool and insert the power load strip. 
  2. Insert the correct fastener or collated fasteners, (without compressing the front of the tool). 
  3. The tool should then be compressed against the work surface. (Making sure that the tool is perpendicular to the work surface). 
  4. Once the tool is compressed the trigger is actuated and the fastener is driven through the material being fastened into the substrate.