Ramset
Ramset

Chemset Injection System

Fast cure, medium duty anchoring of threaded studs and reinforcing bar into solid concrete, stone, hollow brick and hollow concrete block.

Styrene free. Versatile, multi-purpose two part polyester anchoring system.

 Fast cure and fast dispensing for high productivity. Non-drip formula, ideal for overhead installation. Steel columns and beams, seating, machinery, facade pins, handrails, gates, starter bars, bottom plate fixing


Selection Guide

Chemset 101

Versatile, high performance, multi-purpose two part polyester anchoring system. Fast cure for improved productivity. Non-drip formula, ideal for overhead installation.

Metered sytem for controlled fixings per pack

Fast curing (see product for details)

Simple to use

380 ml................C101C
750 ml........................C101J

1x Kit, ISKP (containing 2x 380ml Cartridges and 4x nozzels)

Requires The Chemsetâ„¢ Universal Applicator. Needed to dispense all products and all pack sizes of the Chemsetâ„¢ Injection Adhesive range - one tool does it all!

(refer accessories)

Technical Data Sheet
MSDS Sheet

Chemsetâ„¢ Injection 801 / 802 Anchoring Adhesive

Heavy duty anchoring of threaded studs and reinforcing bar into solid concrete and stone.

Two component Chemical resistant epoxy mortar. Tough and reliable for extra security. High bond strength for diamond core and carbide drilled holes.

High Performance

Metered system for contolled fixings per pack

2 Formulations:

801 Fast cure for use in temperate climates

802 Slow cure for use in tropical climates or for deep holes where longer gel times are needed

380 ml.......................C801C
750 ml.......................C801J

Technical data Sheet
MSDS Sheet

How to use

Chemset Injection System
  1. Before use of this product, read the Technical Data Sheet available as PDF on this site or from the Ramset Idustrial website www.ramset.com.au
  2. Attach only new Ramset mixing nozzle to cartridge. 
  3. Wear protective gloves, clothing and goggles.
  4. Drill correct diameter hole to recommended depth. Clean hole thoroughly with a nylon brush. Remove debris by way of vacuum pump, compressed air, hand pump etc.
  5. Insert mixer nozzle and inject mixture into hole. Insert the stud into the bottom of the hole using a slow twisting motion.
  6. Allow resin to cure as per reccomendations. Attach ficture.
  ITW PROLINE Copyright 2015   customerservice@itwproline.com.au   Sales & Service Support: 1300 721 738   
    Home Corporate info  | Privacy | Disclaimer | Contact us